Table of Contents
Advertisement
8-28
Installation and Maintenance Volume
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name
42. Configuration
Error (continued)
1D =
1E =
1F =
20 =
22 =
23 =
24 =
25 =
26 =
27 =
28 =
29 =
2a =
2b =
2c =
2d =
2e =
Octel 200/300
S.4.1
Source
Error detected in the
Check the configuration tables.
configuration tables
(NOT Octel 200/300)
REMOTE SYSTEM
SUPPORT TURNAROUND
DATA-2 =
LOCATION NUMBER OF REMOTE CABINET IN THE
LOCATION TABLE OF THE LOCAL CABINET
The remote cabinet (not an Octel 200/300) is configured
SOURCE:
to support turnaround. The remote cabinet is an Octel
250/350 or Octel PC, and in its node profile,
RESPONSE ALLOWED
Modify the node profile in the remote cabinet and set
REMEDY:
NODE RESPONSE ALLOWED
NO QUERY REPLY POSSIBLE. Digital network is not up, do not have
domain feature, or both.
DOMAIN FEATURE NOT AVAILABLE
DATA-2 =
TYPE OF ERROR
=
1 = QUERIES BEING RECEIVED FROM FIELD
This means that some other system has this cabinet
configured in the domain.
DATA-3 =
REMOTE HOST HANDLE OF THAT CABINET.
DATA-4 =
UNUSED
OctelNet serial # not configured.
Sent a prefix the remote side did not recognize during Namesend.
Other side does not have the Namesend feature.
Generic Gateway error mailbox has not been configured but is required.
(System Parameter 285)
Go Dial went to initialization prompt.
Names Directory error during Namesend.
Multiple domain location configured with same IP address.
Self numbering plan entry not configured, but matches Alternate self.
Location for destination network mailbox not found. It is possible that the
network mailbox was in a distribution list and the location was deleted.
DATA-2 = First 8 digits of the network mailbox.
No forwarding string defined (system parameter 45) for NPIC.
gtfram error on sdisfrms table. This error is mostly caused by incorrect
configuration of the AP pool that should be an extended mailbox
DATA-2 =
sysdist frame number that caused the problem
DATA-3 =
Number of mailboxes in AP pool yet to scan
Other side does not have the netname feature
DATA-2 =
Location number
SDL member configured to not receive messages
DATA-3 = User number
Outcall digit string exceeds max (20 digits)
DATA-2 =
Length of outcall number
DATA-3 =
User number (0 may indicate network outcall)
Invalid digit in outcall digits
DATA-2 =
User number
DATA-3 =
Position of invalid digit
Remedy
CONFIGURED TO
NODE
has been set to YES for this node.
to NO.
Priority
1
PB60019−01
Advertisement
Chapters
Table of Contents
