Hard Disk Add - Avaya Octel 200 Installation And Maintenance Manual

Hard Disk Add

This section provides procedures for adding a drive to an Octel 200/300. Adding a drive increases system storage or
enables redundancy.
Action
Prepare the System
1. Forward ports.
Boot the System
2. Make sure software disk #1 (for
the correct release level) is
write-protected.
3. Insert software disk #1 (for the
correct release level) into the
floppy drive.
4. Adjust the baud rate of the
terminal/teleprinter. Refer to
Chapter 4, Installation; Terminal
Communications section.
5. Press the Reload button to boot
from floppy disk.
6. When prompted, insert disk 2.
PB60019−01
Octel 200/300 Description and Response
The following message is printed.
Procedures 12-45
Octel 200/300 S.4.1