Table of Contents
Advertisement
YES
NO
3. From telephone A, call outside the PBX and back in on trunks dedicated to the hunt group.
4. Does the Octel 200/300 answer correctly?
YES
NO
5. From the terminal, enter the PS command.
6. Does the port that answered show WFD state?
YES
NO
7. From telephone A, enter the extension number associated with telephone C. The Octel 200/300
responds with "Thank you, just a moment."
8. Does telephone C ring?
YES
NO
9. Enter the PS command. Port status should show port 1 in the AIC (assisted incoming call/automated
attendant) state.
10. Answer telephone C. Does the Octel 200/300 say "Tick, tick, tick,....Connecting" and transfer the
incoming trunk to telephone C?
YES
NO
11. From the terminal, enter the PS command, and verify that the port state is IDL.
12. Busy-out the port that answered.
13. Repeat the procedure from step 3 for all ports, until all ports are busied out. Verify that calls can be
placed through the Octel 200/300 from each port.
14. From telephone A, call out and back in on a trunk dedicated to the hunt group.
15. Does the call overflow to the correct destination?
YES
NO
.
16. Remove the busy condition from all Octel 200/300 port extensions.
17. Repeat steps 3 through 13 except call an extension that does not answer, and then repeat it by calling
a busy extension.
Test to Verify Trunks
1. From telephone A, call outside the PBX and back in on the first trunk dedicated to the
Octel 200/300.
PB60019−01
Continue.
'
'
Determine the cause and correct the problem before continuing.
'
Continue.
Determine the cause and correct the problem before continuing.
'
Continue.
'
Determine the cause and correct the problem before continuing.
'
Continue.
'
'
Determine the cause and correct the problem before continuing.
Continue.
'
Determine the cause and correct the problem before continuing.
'
Continue.
'
'
Determine the cause and correct the problem before continuing.
Some PBXs might not support overflow, in which case a busy condition or a ring-no-answer
condition could be encountered.
Installation
4−35
Octel 200/300
S.4.1
Advertisement
Chapters
Table of Contents
