Table of Contents
Advertisement
Chapters to Read by Job Function
This manual is not written to be read straight through. It is written to be referred to for specific
information. Read the chapters that fit your needs, your job function, or your level of expertise with
Octel 200/300 message servers. The following chart attempts to help you navigate through the volumes.
Volume 4 — Installation and Maintenance
Chapter
INSTALL
Hardware
Preparing the Phone System
Installation
Reports
Maintenance Commands
LOG Commands
System Errors and Traffic
Pegs
Hardware Replacement
DTIC Card
LAN Card
Procedures
Volume 5 — Integration
All Chapters
Volume 6 — Networking
All Chapters
Chapter Description
This sections describes Volume 4 — Installation and Maintenance. For descriptions of the chapters in
Volume 5 — Integration, and Volume 6 — Networking, refer to the Introduction of those volumes.
Volume 4 — Installation and Maintenance
Volume 4 — Installation and Maintenance, contains information about preparing for an Octel 200/300
installation, and about monitoring and maintaining the Octel 200/300 after installation. The following is a
brief summary of each chapter within the Installation and Maintenance volume.
Chapter 1
INSTALL
Chapter 2
HARDWARE
Octel 200/300
S.4.1
Sales
Configuration Implementation
n
n
n
n
n
n
n
n
n
n
n
n
n
Provides instructions about using the
new Octel 200/300 and reinstall an existing system.
Discusses the Octel 200/300 architecture. Included are an overview
of the hardware, description of subsystems, and system diagrams.
Installation
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
program to install a
INSTALL
Service/
Maintenance
n
n
n
n
n
n
n
n
n
n
n
n
n
PB60019−01
Advertisement
Chapters
Table of Contents
