Fax Application Processor Replacement - Avaya Octel 200 Installation And Maintenance Manual

Fax Application Processor Replacement

The Octel 200/300 fax application processors (fax cards) installed in shelf A are hot pluggable. That
means you do not have to turn OFF the message server to remove or install the cards. Figure 9-15 is a
diagram of a fax card.
Red
Green
Amber
Card Ejector
Removing Fax Application Processors
Use the following procedure to remove a fax card:
1. Before servicing a fax application processor, use the Courtesy Down command to take the fax card
out of service. At the @ prompt, enter
CD x
In this command, x is the slot number.
2. Unlock and open the door of the cabinet.
3. Put on an antistatic wrist strap. Connect it to an unpainted portion of the cabinet.
4. Remove the fax card from the Octel 200/300 cabinet by pivoting the plastic card ejectors at the top
and bottom front edge of the card and sliding the card out of the card cage.
.
5. Store the removed fax card in a static protection bag.
PB60019−01
Card Ejector
SIMM
Modules
Figure 9-15 Fax Application Processor
Enter
Handle the fax card only by the top and bottom edges. Do not touch components on the card.
SIMM Modules
Card Stiffeners
Orientation Label
Front
Fax Daughter Card 2 (channels 5−8)
(solder side up)
Front
Fax Daughter Card 1 (channels 1−4)
(solder side up)
Hardware Replacement 9-23
Octel 200/300 S.4.1