Avaya Octel 200 Installation And Maintenance Manual page 410

8-24 Installation and Maintenance Volume
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name
41. Visual Mailbox
Hardware Error
DATA-1 = LAN ERROR TYPE AS FOLLOWS:
01 = NO RESPONSE FROM LAN CONTROLLER AFTER CONTROLLER RESET
02 = NO INTERRUPT RECEIVED FROM LAN AFTER CONTROLLER ENABLED
03 = INCORRECT ID STRING STORED BY CONTROLLER AFTER RESET
DATA-2 = FIRST BYTE OF ID STRING (SHOULD BE D1 HEX)
20 = PACKET TRANSMISSION WAS NOT ACKNOWLEDGED AFTER 5
21 = NETWORK RECONFIGURATION OCCURRED DUE TO TOKEN RING
Octel 200/300 S.4.1
Source
Command link
interface LAN is
malfunctioning or has
detected a network
error
DATA-3 = SECOND BYTE OF ID STRING (SHOULD BE NODE ID)
SECONDS
DATA-2 = DESTINATION NODE ID
INACTIVITY
Remedy
This is a Visual Mailbox error. First check
that Visual Mailbox is functioning properly.
If it is, this is a false alarm or the condition
has corrected itself.
Check to see if the cable from the
Octel 200/300 to the Gateway is properly
connected and secured. Restart the
Gateway. If the problem still exists, replace
the CLI board in the Gateway.
Priority
3
2
PB60019−01