Table of Contents
Advertisement
Table 8-2 Hardware Error Types and Remedies (continued)
Error Type:Name
DATA-1
Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 2:
Bit 1:
Bit 0:
DATA-2
Bit 7:
Bit 6:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
DATA-3
Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
DATA-4
Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 0:
36. System RAM
Error
The DATA-1 field specifies the type of error. DATA-2 through DATA-4 are data
associated with the error.
DATA-1 =
ERROR CODE:
01 =
PB60019−01
Source
+5 volts clean out of range.
+5 volts VCC out of range.
Analog to Digital Converter error.
Interval timer error.
DRAM address or pattern error.
EPROM/Flash checksum error.
Fatal Processor error.
DMA page register error.
Unexpected interrupt error.
Temperature out of rage.
−12 volts out of range.
−5 volts clean out of range.
+12 volts motor supply out of range.
+12 volts clean out of range.
TDM crosspoint pattern or address error.
Modem loopback or download error.
UART channel 1 or 2 error.
Watchdog timer error.
Optional Control chip error.
Floppy disk controller error.
Real Time Clock error.
DMA register or transfer error.
Internal status register error
Ethernet Controller error.
Voice Bus Controller error.
SCSI Controller error.
TDM Codec loopback error.
Board Information Chip error.
Control Bus Controller / shared memory error.
Cache module found
an error with system
RAM, CPU and/or
VCU.
FIRMWARE REPORT OF RAM SIZE NOT EVEN MEGABYTE
Remedy
Call your technical support center for
remedy.
System Errors and Traffic Pegs
Priority
3
Octel 200/300
8-21
S.4.1
Advertisement
Chapters
Table of Contents
