Exiting And Continuing; Reinstalling An Installed Octel 200/300 - Avaya Octel 200 Installation And Maintenance Manual

1-28 Installation and Maintenance Volume

Exiting and Continuing

If you start INSTALL and are interrupted, you can leave the program and continue later at the point
where you left off. The following example, starting at question 1.c), shows how.
c) What is the SYSTEM ID number? (1−6 digits).
:555
d) How many (Octel 200/300) ports will be used? (1−8, empty line = 4)
:.E
EXITING INSTALL
WAIT...DONE
−−−−−−−−−−−−−−−SYSTEM INSTALLATION SUSPENDED−−−−−−−−−−−−−
@
Later, when you want to continue, type INSTA at the @ prompt, as shown.
@INSTA
−−−−−SYSTEM CONFIGURATION DIALOG−−−−−
DAY
You have an installation already in progress.
Do you wish to start over with a NEW INSTALLATION?
(Y/N, Empty line = NO, continue installation in progress)
:
d)How many ports will be used? (1−8, empty line = 4)
:
Begin entering data where you left off.

Reinstalling an Installed Octel 200/300

After the Octel 200/300 is installed, situations could arise that warrant a reinstallation:
The PBX has been replaced.
-
There were errors during INSTALL. (Instituting a reinstallation might be more time-efficient
-
than correcting major errors.)
During a reinstallation, you can use the following options to:
Reinstall the Octel 200/300, answering every question in the INSTALL program.
-
Preload all the configuration tables from the backup configuration disk.
-
Preload the specific range of tables.
-
Octel 200/300 S.4.1
MM/DD HH:MM:SS YYYY SYSTEM NAME ID:000
PB60019−01