Octel 200 Diagrams - Avaya Octel 200 Installation And Maintenance Manual

Hide thumbs Also See for Octel 200:

Table of Contents

Installation and Maintenance Volume

Power Supply Output

The AC and DC wiring is prewired to connectors that are automatically engaged when the power supply

is installed. There are no power-supply adjustments. You can check voltages by using a digital volt meter.

Using the digital volt meter, you can measure the system DC voltages at the voltage test points on the

front edge of the CPU. Refer to the Installation chapter, Octel 200/300 Hardware Installation section in

this volume.

Preventive Maintenance Tools and Equipment

The tools and equipment required to perform preventive maintenance on the Octel 200/300 are:

Key to front door

Antistatic wrist strap

Digital volt/ohm meter

Three standard, touch-tone telephones

Telephone test set (butt set)

Large, flat-blade screwdriver

11/32 nut driver

No. 1 Phillips screwdriver

Octel 200 Diagrams

Use the following Octel 200 diagrams to provide assistance when performing preventive maintenance or

replacing components. Figure 9-1 through Figure 9-4 shows the Octel 200 shelf structure, front, and rear

Octel 200/300

5/16 hex socket driver

Breakout box

Digit grabber

RS-232C-compatible ASCII send/receive

terminal capable of 300, 1200, or 9600 baud.

(Refer to the Installation chapter, Terminal

Communications section, in this manual.)

Table of Contents