Viewing And Modifying Ima And Uni Groups - 3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual

142 C 5: C
HAPTER ONFIGURING
P B S700 M
ATH UILDER ODULES

Viewing and Modifying IMA and UNI Groups

Once you have added a group, you use the List/Modify Group menu to view and
modify group configuration parameters.
To view and/or modify an existing group, follow these steps:
1 From the Group menu, shown earlier in Figure 99, select [1] List/Modify Group to
open the List/Modify Group Selection menu. Figure 103 shows the E1 List/Modify
Group Selection menu. The DS1 menu is the same. The List/Modify Group
Selection menu lists the existing groups, by group number.
Figure 103 List/Modify Group Selection Menu
2 Enter the number corresponding to the group you want to view or modify to
display the Group Configuration Options menu for that group. Figure 104 shows
the E1 UNI Group Configuration Options menu. The DS1 UNI menu is the same.
The options on this menu allow you to access other menus from which you can
configure group parameters or virtual interfaces.
Figure 104 Group Configuration Options Menu
, P , A
ORTS AND PPLICATIONS