Viewing And Modifying Ima And Uni Groups; Deleting Ima And Uni Groups - 3Com SuperStack II PathBuilder S330 Reference Manual

Viewing and Modifying IMA and UNI Groups

Once you have added a group, you use the List/Modify Group menu to view and
modify group configuration parameters.
To view and/or modify an existing group, follow these steps:
1 From the Group menu, shown in Figure 61, select [1] List/Modify Group to open
the List/Modify Group Selection menu.
2 Enter the number corresponding to the group you want to view or modify to
display the List/Modify Group menu for that group. Figure 67 shows the
List/Modify Group menu for an IMA group. The List/Modify Group menu for a UNI
group is similar, but it lists only the parameters you can set for UNI groups: Admin
Ports and Admin Status.
Figure 67 Modifying an Existing IMA Group
3 If the Admin. Status of the group is In Service, select [10] Set Admin. Status and
enter 1 to take the group out of service.
You must take the group out of service before you can modify it.
4 Change any of the group parameters as desired.

Deleting IMA and UNI Groups

To delete an existing IMA or UNI group, follow these steps:
1 From the Group menu, shown in Figure 61, select [3] Delete Group to open the
Delete Group Selection menu.
2 Enter the number corresponding to the group you want to delete to open the
Delete Group menu, shown in Figure 68. This menu lists the parameters for the
selected group and warns you that deleting the group will delete any virtual
circuits using that group.
Configuring the T1/E1 Interface 97