Table of Contents
Advertisement
178
C
5: C
HAPTER
ONFIGURING
Configuring the
QSIM/HSIM/FAM Local
Management Interface
P
B
S700 M
ATH
UILDER
ODULES
Table 39 FAM Performance at Small Frame Sizes
Max. Frames
per second on
Frame Size
each port
64
2908
2908
2695
1796
1328
128
1460
1460
1460
To configure the QSIM/HSIM/FAM Local Management Interface (LMI), follow these
steps:
LMI configuration applies only to Frame Relay ports. The LMI Configuration menu
is not available if the QSIM, HSIM, or FAM port is configured as a DXI or
HDLC/SDLC port.
1 From the List Card menu, select the number corresponding to the slot in which the
QSIM, HSIM, or FAM is installed. The QSIM, HSIM, or FAM Configuration Port/Card
Selection menu appears, as shown earlier in Figure 138.
2 Select the number corresponding to the port you want to configure: 1-4 for the
QSIM; 1 for the HSIM; 1-8 for the FAM. The QSIM, HSIM, or FAM Port
Configuration Selection menu appears, as shown earlier in Figure 139.
3 Select [2] LMI Configuration to display the LMI Configuration menu for the
selected port. This menu displays the LMI configuration and provides options that
allow you to change certain parameters.
LMI configuration relates to the periodic polling that is performed between pairs
of Frame Relay devices to determine the status of PVC connections and to verify
the link integrity. This polling is done through a procedure known as Status
Enquiry. Two types are polling are performed: full status (FS) and link integrity
verification (LIV). Full status polling also includes link integrity verification.
Figure 141 shows the QSIM LMI Configuration menu. The HSIM and FAM LMI
Configuration menus are similar.
, P
,
A
ORTS
AND
PPLICATIONS
Total Packets
Number of
on card
Active Ports
(duplex)
4
23264
5
23264
6
32340
7
25144
8
21248
4
11680
6
17520
8
23360
Advertisement
Table of Contents
