Performing Initial Configuration - 3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual

Performing Initial
Configuration
Figure 32 Alarm Indicator
Select to display
menu from which
you can access
screen listing
current alarms
After you acknowledge the alarm, the alarm indicator is no longer highlighted, but
the word "Alarm" remains in the upper right corner of the screen to indicate that
an alarm has been acknowledged.
When the alarm is acknowledged and the condition that caused the alarm is
cleared, the indicator disappears entirely. If a menu indicates that an alarm has
been acknowledged and a new alarm occurs, the Alarm indicator is highlighted
again.
See "Managing System Alarms" in Chapter 6 for instructions on acknowledging
alarms.
After you install the PathBuilder S700 hardware, you must complete the following
three steps in order to complete the initial configuration:
1 Set up communication parameters
2 Configure In-band Management (optional)
3 Set up passwords
4 Set the time and date
You access the menus used to perform these steps from the System
Administration menu, shown in Figure 33. To display the System Administration
menu:
From the Main menu, select [1] System Administration.
Performing Initial Configuration
Indicates that an
alarm has been
detected
61