Configuring The Bridge - 3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual

Configuring the Bridge
4 Configure input shapers for the Ethernet card.
a From the Ethernet Configuration menu, select [4] Shaper Configuration to
display the Ethernet Shapers screen. This screen is the same as the MCPU Input
Shapers screen, shown earlier in this chapter in Figure 88.
b To enter a new shaper value, use the arrow keys on your keyboard to move to
the cell in the shaper table that you want to change.
You can set three input shaper parameters for the Ethernet card:
Peak Cell Rate (PCR)
n
Sustained Cell Rate (SCR)
n
Maximum Burst Size (MBS)
n
For detailed instructions about configuring input shapers, see "Configuring
Input Shapers" earlier in this chapter.
c Press [Esc] to return to the Ethernet Configuration menu.
5 Configure virtual interfaces for the Ethernet card.
a From the Ethernet Configuration menu, select [5] Virtual Interfaces to open the
Virtual Interfaces Configuration menu. This menu is the same as the MCPU
Virtual Interfaces Configuration menu, shown earlier in this chapter, in
Figure 84.
b Configure virtual interfaces as described under "Configuring Virtual Interfaces"
earlier in this chapter. You configure virtual interfaces for the Ethernet card in
the same way that you configure virtual interfaces for the MCPU card.
All of the virtual channels assigned to a particular slot and port form a network
bridge. In order to enable the Ethernet port to operate, you must configure the
bridge with the required user-filtering options and an aging timer value.
To configure the bridge, follow these steps:
1 From the Configuration Management menu, shown earlier in Figure 80, select
[3] Manage Bridge to display the Manage Bridge menu, shown in Figure 116.
Figure 116 Manage Bridge Menu
Configuring Ethernet Modules 153