Table of Contents
Advertisement
180
C
5: C
HAPTER
ONFIGURING
Configuring
QSIM/HSIM/FAM Cards
P
B
S700 M
ATH
UILDER
ODULES
User Error Threshold (N392) / User ME Count (N393)—These parameters
are related. The User ME (Monitored Event) Count is the threshold period that
you set to determine a service-affecting condition. The unit monitors
events—receipt STATUS ENQUIRY messages or expiration of polling timers—for
the number of seconds (3..10) that you specify. Within this specified User ME
Count period, if an error occurs within the number of seconds that you specify
as the User Error Threshold (3..10), the system declares an error.
You must set the User Error Threshold to a lower value than that of the User ME
Count.
Configuring a QSIM/HSIM/FAM card involves the following tasks:
Configuring the card itself
n
Configuring input shapers
n
Configuring virtual interfaces
n
To configure the QSIM/HSIM/FAM card, follow these steps:
1 Configure the card itself.
a From the List Card menu, select the number corresponding to the slot in which
the QSIM, HSIM, or FAM is installed: [4], [5], or [6]. The QSIM Configuration
menu, shown earlier in Figure 138, appears.
b Select [5] Card Configuration ([9] Card Configuration on the FAM menu) to
display the QSIM, HSIM, or FAM Card Configuration menu. Figure 142 shows
the QSIM Card Configuration menu. The HSIM and FAM Card Configuration
menus are the same. The QSIM, HSIM, and FAM Card Configuration menus
display the current QSIM/HSIM/FAM card configuration and provide options
that allow you to change certain parameters.
Figure 142 QSIM Card Configuration Menu
, P
,
A
ORTS
AND
PPLICATIONS
Advertisement
Table of Contents
