Configuring Trap Clients - 3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual

66 C 3: G S
HAPTER ETTING TARTED
Figure 39 SLIP Port IP Configuration Menu
3 Enter the following information (by selecting the appropriate options and
responding to the prompts that appear at the bottom of the screen) to enable IP
Ethernet connectors:
IP Address—Provided by the network administrator. This is the IP address of the
PathBuilder S700 Management CPU.
You should consult the network administrator to obtain an IP address for the
PathBuilder S700 which will allow its 10BaseT Management port to co-exist with
hosts on its local LAN.
Subnet Mask—Provided by the network administrator. The subnet mask
identifies the subnetwork containing the PathBuilder S700 SLIP management port.
4 Select [3] Previous Menu to return to the Local Host IP Configuration menu.
5 Select [3] Apply IP Configuration Changes to activate the IP address. The following
prompt appears:
This action will terminate all running TELNET/SNMP sessions.
Are you sure you want to apply IP configuration changes (Y/N)[N]?
6 Enter y to apply your changes.
Configuring Trap Clients
The PathBuilder S700 can report SNMP trap alarms to a remote management
system. Trap clients are the network management stations to which you want the
PathBuilder S700 to send traps. You can specify up to four trap clients. To
configure trap clients, follow these steps:
1 From the Manage IP Network Configuration menu, select [2] Trap Client
Configuration to display the Trap Client Configuration menu, shown in Figure 40.