Viewing The Firmware Version - 3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual

Viewing and Configuring System Information 111
Figure 77 RS-232 Port #2 Configuration Menu
2 Change any of the following parameters as desired:
Baud Rate—300, 1200, 2400, 4800, 9600, 19200, or 38400
Parity—one, even, or odd
Data Bits—7 or 8
Stop Bits—1 or 2
When you make a change to the port to which you are currently connected, it
does not take effect until you log out. After you log out, change the configuration
of your terminal port to agree with that of the PathBuilder S700 management port
and then start a new session.
Changing to a slower baud rate may slow down communications to the point
where it is obvious on the display (menus will change and form more slowly).
Conversely, increasing the baud rate will speed up the menu system.
Viewing the Firmware To view the version number for the firmware that is currently running on the CPU:
Version
From the System Administration menu, select [7] Report Firmware Version.
The Report Firmware Version screen appears, as shown in Figure 78.