Setting Up Communication Parameters - 3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual

62 C 3: G S
HAPTER ETTING
Setting up
Communication
Parameters
TARTED
Figure 33 System Administration Menu
The following subsections provide instructions for performing the three initial
configuration steps. See Chapter 5 for instructions on configuring specific
PathBuilder S700 modules.
In order for the PathBuilder S700 to communicate to the Ethernet network, you
must set the correct communication parameters. To do this, select [3] Manage IP
Network Configuration from the System Administration menu to display the
Manage IP Network Configuration menu, shown in Figure 34.
Figure 34 Manage IP Network Configuration Menu
From the Manage IP Network Configuration menu, you configure the following:
Local host IP address
n
Trap client
n
Default gateway
n
The subsections following the figure describe how to set these parameters.