Modifying An Interface - 3Com LANPLEX 6000 User Manual

Top-Level Menu
system
ethernet interface
fddi display
route
tokenring define
arp
bridge
rip
modify
ip ping
remove
statistics
snmp
analyzer
script
logout
Top-Level Menu
system
ethernet
interface
fddi display
route
bridge arp define
rip modify
ip
ping
snmp remove
statistics
analyzer
script
logout
Administering
Routes

Modifying an Interface.

To modify an IP interface that you have already defined:
1 From the top level of the Administration Console, enter:
ip interface modify
2 Enter the slot of the switching module for which you want to modify an
interface.
You are prompted for the interface parameters. Press [Return] at the
prompts for which you do not want to modify the value.
3 Modify the existing interface parameters by entering a new value at the
prompt.
Removing an Interface
You may want to remove an interface if you no longer need to
communicate with IP on the ports associated with the interface.
To remove an IP interface definition:
1 From the top level of the Administration Console, enter:
ip interface remove
2 Enter the slot of the switching module from which you want to remove an
interface.
3 Enter the index number(s) of the interface(s) you want to remove.
Each switching module maintains a table of routes to other IP networks,
subnets, and hosts. You can either make static entries in this table using the
Administration Console or configure switching modules to use RIP to
exchange routing information automatically.
Setting up an IP Interface for Management 3-9