3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual page 201

Configuring Virtual Circuits 187
Figure 149 Add Virtual Circuit Screen—Entering the First VC Parameter for Side A
4 Follow the prompts that appear at the bottom of the screen, pressing [Enter] after
each entry. Default values are listed in square brackets ([ ]) at the end of each
prompt.
Your settings are added to the list of parameters at the top of the screen as you
enter them. You must enter a setting for all the parameters for which you are
prompted in order to add a circuit. Press [Delete] to back up to a previous
selection.
Some parameters that appear on the Add Virtual Circuit screen may not apply to
the particular circuit you are configuring. The system skips any non-applicable
parameters and does not allow you to set them. In addition, certain parameters
may be displayed for information only; you cannot change these read-only values.
When you have entered a setting for each parameter on side A of the circuit, the
Add Virtual Circuit again displays the list of available PathBuilder S700 cards, by
slot number, and prompts you to enter a slot number for side B of the circuit, as
shown in Figure 150.