28
C
2: I
HAPTER
NSTALLATION
Connecting an Ethernet
Module
Figure 12 DS1/E1 UNI LEDs
The green indicator light illuminates to show that the port is in service.
n
The red indicator light illuminates to show that the port is not in service.
n
Connect an Ethernet module to the LAN directly or through a hub, as shown in
Figure 13, Table 8 lists the RJ48 connector pinouts.
Table 8 Ethernet Module Connector Pinouts
PIN 1
TX+
PIN 2
TX-
PIN 3
RX+
PIN 4
PIN 5
PIN 6
RX-
PIN 7
PIN 8
The cable runs from the PathBuilder S700 Ethernet ports to the Ethernet LAN
connections must be no longer than 100 meters in compliance with EIA/TIA
standards for 10BaseT. The cable lengths should include service loops at the ends
and the complete cable route distances.
Slot 1
Slot 18