Table of Contents
Advertisement
®
SuperStack
(3C16471) User Guide
DUA1647-0AAA01
I
NTRODUCTION
®
The SuperStack
3 Baseline 10/100 Switch is a versatile,
easy-to-use unmanaged switch. It is ideal for users who want the
high-speed performance of 10/100 switching but do not need
sophisticated management capabilities. The Baseline 10/100
Switch is shipped ready for use. No configuration is necessary.
The Baseline 10/100 Switch has 16 or 24 shielded RJ-45,
10/100 Mbps auto-negotiating ports on the front panel. Each port
automatically determines the speed and duplex mode of the
connected equipment and provides a suitable switched
connection. Each port also supports automatic MDI/MDI-X
detection.
The Baseline 10/100 Switch is suited for office use where it can
be free standing, or rack mounted (in a wiring closet or
equipment room).
The Baseline 10/100 Switch comes with:
One power cord for use with the Baseline 10/100 Switch
Four self-adhesive rubber pads
One mounting kit
The Switch is powered from the AC mains supply.
The Baseline 10/100 Switch provides high performance switched
connections to 10 Mbps and 100 Mbps hubs, servers and
workstations that require a dedicated switched link.
3 Baseline 10/100 Switch 16-Port (3C16470) and 24-Port
The diagram below shows an sample configuration:
Baseline Hub
Baseline Dual Speed Hub
Baseline 10/100 Switch
10Mbps link
1
Endstations on shared
10Mbps connections
Endstations on shared
100Mbps connections
100Mbps connection
to backbone
Endstations on switched
10Mbps connections
100Mbps link
Advertisement
Table of Contents
Related Manuals for 3Com Baseline 3C16470
Summary of Contents for 3Com Baseline 3C16470
- Page 1 ® SuperStack 3 Baseline 10/100 Switch 16-Port (3C16470) and 24-Port (3C16471) User Guide DUA1647-0AAA01 NTRODUCTION ® The SuperStack 3 Baseline 10/100 Switch is a versatile, easy-to-use unmanaged switch. It is ideal for users who want the high-speed performance of 10/100 switching but do not need sophisticated management capabilities.
-
Page 2: Front Panel
OW TO SE THE Numbered elements in this diagram refer to numbered sections in the text. A 24-port unit is shown. Front Panel 24 RJ-45 10/100 Ports WARNING : RJ-45 ports. These are shielded RJ-45 data sockets. They cannot be used as standard traditional telephone sockets, or to connect the unit to a traditional PBX or public telephone network. -
Page 3: Rear Panel Connections
Water or moisture cannot enter the case of the unit. Air flow around the unit and through the vents in the side of the case is not restricted (3Com recommends that you provide a minimum of 25 mm (1 in.) clearance). -
Page 4: Wichtige Sicherheitsinformationen
AFETY NFORMATION Please read the following safety information carefully before installing the Baseline 10/100 Switch. WARNING: Installation and removal of the unit must be carried out by qualified personnel only. If installing the Switch unit in a stack with other SuperStack 3 units, the Baseline 10/100 Switch unit must be installed below the narrower Hub units. -
Page 5: Rack Mounting The Units
OUNTING Introduction The Baseline 10/100 Switch is supplied with two mounting brackets and four screws. These are used for rack-mounting the unit. When mounting the unit, you should take note of the guidelines given in “Positioning the Baseline 10/100 Switch” on page 3. -
Page 6: Vcci Statement
ECHNICAL UPPORT The following options are available for technical support: In the first instance contact your Network Supplier. Check the 3Com knowledgebase at http://knowledgebase.3com.com Browse the 3Com web site on http://www.3com.com Country Asia, Pacific Rim Australia Hong Kong India Indonesia... - Page 7 3Com Technologies. 3Com Technologies reserves the right to revise this documentation and to make changes in content from time to time without obligation on the part of 3Com Technologies to provide notification of such revision or change. 3Com Technologies provides this documentation without warranty of any kind, either implied or expressed, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
-
Page 8: Product Registration
Product Registration You can now register your SuperStack 3 Baseline 10/100 Switch on the 3Com web site: http://support.3com.com/registration/frontpg.pl Documentation Feedback Your suggestions are very important to us. They will help make our documentation more useful to you. Please e-mail comments about this document to 3Com at: pddtechpubs_comments@3Com.com...