3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual page 81

Figure 40 Trap Client Configuration Menu
2 Select the number corresponding to the trap client you want to configure.
Figure 41 shows the menu for configuring trap client 1.
Figure 41 Trap Client 1 Configuration Menu
3 Enter the following information (by selecting the appropriate options and
responding to the prompts that appear at the bottom of the screen) to configure
the trap client:
IP Address—The IP address of the network management station to which you
want the PathBuilder S700 to send traps.
Subnet Mask—The subnet mask for the network management station to which
you want the PathBuilder S700 to send traps.
Port Number—The system-defined port number. You should not modify this
number.
4 Select [4] Previous Menu to return to the Trap Client Configuration menu.
5 Select [5] Previous Menu to return to the Manage IP Network Configuration menu.
Performing Initial Configuration 67