Viewing Automatically Configured Ip Information - 3Com 4200G Getting Started Manual

48 C 3: S
HAPTER ETTING
Viewing
Automatically
Configured IP
Information
Using 3Com Network
Director
U M
P FOR ANAGEMENT
6 Enter the IP address and subnet mask for the switch:
ip address xxx.xxx.xxx.xxx mmm.mmm.mmm.mmm
(where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmm is
the switch's subnet mask)
7 Enter a default gateway for the switch:
ip route-static 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx
(where xxx.xxx.xxx.xxx is the IP address of the default gateway)
8 From the User View, enter the save command to save the configuration
to your Switch as the configuration is not saved automatically when the
Switch is powered down.
The initial set up of your Switch is now complete and the Switch is ready
for you to set up your chosen management method. See "Methods of
Managing a Switch" on page 37.
If you allow the switch to automatically configure its own IP information
you need to discover and view the IP information before you can begin to
manage the switch by:
Using 3Com Network Director to auto-discover the switch and display
■
the its automatically allocated IP information.
Connecting a workstation to the switch's console port using a console
■
cable, then using the command line interface to view its automatically
assigned IP information.
Each method is described in detail below.
You can use the 3Com Network Director application (available from the
3Com website) to discover the automatically allocated IP information.
1 Connect your switch to the network.
2 Power-up the switch and wait for two minutes.
3 Launch 3Com Network Director and run the Auto-discovery wizard.
3Com Network Director automatically discovers the new switch and
displays the its automatically assigned IP information.
Most DHCP and BootP servers allow you to configure static IP addresses
so that you know what the switch's IP address is. Refer to the