Community Name—Enter "3Com" (The community name applies to Ethernet
port IP configuration only.)
Figure 38 shows a sample PathBuilder S700 IP host setup.
Figure 38 Sample PathBuilder S700 IP Host Setup
PathBuilder
S700
192.73.30.99
192.73.30.100
4 Select [4] Previous Menu to return to the Local Host IP Configuration menu.
5 Select [3] Apply IP Configuration Changes to activate the IP address. The following
prompt appears:
This action will terminate all running TELNET/SNMP sessions.
Are you sure you want to apply IP configuration changes (Y/N)[N]?
6 Enter y to apply your changes.
To enter configure the SLIP management port, follow these steps:
1 From the Manage IP Network Configuration menu, select [1] Local Host IP
Configuration to display the Local Host IP Configuration menu, shown earlier in
Figure 36.
When you apply a change to this menu, you might get logged out if you are using
a Telnet session. The default configuration is: Baud Rate, 9600; Parity, none; Data
Bits, 8, and Stop Bits, 1.
2 Select [2] SLIP Port IP Configuration to display the SLIP Port IP Configuration menu,
shown in Figure 39.
3Com
Community
Performing Initial Configuration
65