Printme Setup Options - EFI KM-C1530 Configuration Manual

4
4-44 Performing Setup from the Control Panel

PrintMe Setup options

PrintMe allows users to access and print their e-mail messages, Internet content, and
other documents anytime, anywhere, from any device, to the Fiery X3e.
Jobs sent with a PrintMe account are only sent through the Fiery X3e
N :
OTE
Direct connection.
For more information about PrintMe, go to www.printme.com.
T P ME
O ACCESS RINT SETUP OPTIONS
1. In the main Setup menu, choose PrintMe Setup.
2. Enter the options appropriate to the printing requirements at the site.
3. When you have finished, save changes.
In the following list of options, default values, where applicable, appear in square
brackets.
Enable PrintMe
Yes/No [No]
To enable PrintMe, you must first set up DNS. For information on DNS Setup, see
page 4-14. Select Yes to enable PrintMe, select Save, and exit Setup.
The Fiery X3e restarts and acquires the 16-digit activation code required to proceed
with PrintMe Setup. Immediately after the Fiery X3e restarts, a PrintMe activation
page is printed with the Fiery X3e PrintMe activation code.
From any web enabled computer, go to www.printme.com and click Activate Stations.
Enter the 16-digit activation code that was printed on the PrintMe confirmation page.
We highly recommend that you enter your PrintMe activation code within an
N :
OTE
hour from the time it is printed. Your activation code may become invalid if you try to
enter your code after this time elapses. If this happens, you must disable PrintMe in
Setup, allow the Fiery X3e to restart, and go through PrintMe Setup again to get a
valid activation code.