Stages Of Installation On The Network - EFI KM-C1530 Configuration Manual

1
1-2 Connecting to the Network

Stages of installation on the network

Installation can be performed by a network or printing administrator. The stages of a
successful installation are:
• Physically connecting the Fiery X3e to a functioning network
Prepare a network node for the Fiery X3e—obtain cable, route it to the location where
the Fiery X3e will be installed, and attach the cable to the network interface. For
details, see page
• Configuring the network server
When network servers are required, you need to configure those servers to provide
client access to the Fiery X3e as a PCL or PostScript printer. For information on
configuring network servers in Windows and UNIX network environments, see
Chapter 2.
• Setting up the Fiery X3e
Configure the Fiery X3e for your particular printing and network environment.
First read Chapter
• Preparing client workstations for printing
Install the files needed for printing, install additional user software, and connect the
client to the Fiery X3e over the network. These steps are described in the
Installation Guide, and some information is also provided in
• Administering the Fiery X3e
Monitor and maintain system performance and troubleshoot problems that arise.
For details, see
3-8.
2, and then see subsequent chapters for details.
Chapter 7 of this manual and the
User Software
Chapter 2.
Job Management Guide.