Port Setup Options - EFI KM-C1530 Configuration Manual

4
4-9 Network Setup options
8. When you have finished entering protocol settings, choose Exit Protocol Setup, and
9. Enter the appropriate settings for the services you will use.
T N
O EXIT ETWORK
1. When you have finished entering service settings, choose Exit Network Setup.
2. Choose Yes when prompted to save changes.
3. From the main Setup menu, choose another Setup or choose Exit Setup.
Network Setup
Port Setup
then choose Service Setup.
The options are described in detail in the following pages.
S
ETUP

Port Setup options

You can enable Ethernet and parallel communication simultaneously. To configure
the Fiery X3e, choose each port type you use and enter the settings for that port.
Since network setups are nested, the names of higher-level menus are shown in this
chapter to the left of each menu heading.
Ethernet Setup
Enable Ethernet
Yes/No [Yes]
Select Yes if you have Ethernet cabling connected to the Fiery X3e.
Ethernet Speed
Auto Detect/100 Mbps/10 Mbps [Auto Detect]
Select Auto Detect if your network environment is mixed or if you do not know the
network speed. If you know the speed of the network to which the Fiery X3e is
attached (10 Mbps or 100 Mbps), select it.