2
2-3 Fiery X3e on a TCP/IP network with Windows NT 4.0/2000/XP
Configuring a Windows NT 4.0/2000 server to communicate with
the Fiery X3e
To configure a Windows NT 4.0/2000 server to communicate with the Fiery X3e,
follow these general steps. More detail is provided in subsequent sections in this
chapter and in your Microsoft documentation.
•
Load the TCP/IP network protocol on the server and configure it with an IP address,
subnet mask, and gateway.
•
Enter the host name of the Fiery X3e in the host database used by your system (see
page
2-4).
•
Perform Fiery X3e Setup.
•
On the Windows NT 4.0/2000 server, create a printer for each Fiery X3e print
connection, install the appropriate printer drivers, and (optionally) share the printer
on the network (see
•
Enter the host name and remote printer name of the Fiery X3e in the printer
connection. For more information, see
•
If the Windows NT 4.0/2000 server is also a workstation, install Fiery utilities (see
the
User Software Installation
Adding the Fiery X3e to the TCP/IP network
If your TCP/IP network consists of Windows NT 4.0/2000 servers, and
Windows NT 4.0/2000/XP clients, follow the procedures in this section. If the
network also includes UNIX workstations, see the procedures on
page
2-4).
page
2-17.
Guide).
page
2-17.