Appendix A: Troubleshooting; Troubleshooting The Fiery X3E; Troubleshooting During Setup From The Control Panel - EFI KM-C1530 Configuration Manual

A
A-1 Troubleshooting
Appendix A:
Troubleshooting
After this Setup screen
Enable AppleTalk
(Network Setup>Protocol
Setup>AppleTalk Setup)
Protocol Setup or Service
Setup (Network Setup)
Frame Type selection
(Network Setup>Protocol
Setup>IPX/SPX Setup)
This chapter provides troubleshooting tips.

Troubleshooting the Fiery X3e

Startup diagnostics are described in the Installation and Service Guide for service
technicians. Contact your authorized service/support center if you see startup error
messages on Command WorkStation or if the Fiery X3e does not reach the Idle state.

Troubleshooting during Setup from the Control Panel

The following section explains some error and alert messages you may see during Setup
that might not be self-explanatory.
Network Setup messages
This message
No AppleTalk zone found.
You must first enable
a network port.
Invalid frame size.
Warning! IPX network
number is zero.
Means
The Ethernet network cable is not attached to the
connector on the Fiery X3e, or the network cable is not
plugged into the hub or network. If your AppleTalk
network has zones, and you want to specify a zone for the
Fiery X3e, you must connect the network cable to the
Fiery X3e before performing AppleTalk Setup.
Could also mean the AppleTalk network does not have
zones. Zones are not required for printing to the Fiery X3e.
Press OK to continue.
Enable at least one network port (Ethernet) in Port Setup
before beginning Protocol Setup or Service Setup.
The network hub is not connected to a Novell machine
when the Fiery X3e tries to bind.
No other IPX machine can be found on the network, or
the network hub is not connected to the network when the
Fiery X3e tries to bind. When this occurs, the network
number defaults to zero.