Network Setup Options - EFI KM-C1530 Configuration Manual

4

4-7 Network Setup options

Network Setup options
When you perform Network Setup, you configure the Fiery X3e to receive print jobs
over the network systems that are used at your site.
In the Setup menu, choose Network Setup, where you specify network addresses and
names to be used by workstations, servers, and the Fiery X3e when they communicate
with each other.
The Network Setup menu includes three submenus that allow you to choose port
types, protocols, and network services. You must perform Port Setup and enable at
least one port.
For each item you enable, you are prompted to enter settings for that item. Default
values, where applicable, appear in this manual with square brackets.
You should display and select options only for the network systems that are currently
used at your site. If your network requirements change, you can change Network
Setup at any time.
If the Fiery X3e is configured to enable more than one protocol, it automatically
switches to the correct protocol when it receives a print job. When the parallel port
and one or two network ports are enabled, print jobs can be received over all of those
ports at the same time.