EFI KM-C1530 Configuration Manual page 70

4
4-16 Performing Setup from the Control Panel
Select Frame Types
Enable IPX Auto Frame Type
Yes/No [No]
Specify whether the Fiery X3e should try to bind to all available frame types
automatically. The Fiery X3e does so whether or not all frame types are appropriate.
To determine the frame types that were successfully bound, save your changes, exit
Setup, restart the Fiery X3e, and print a Configuration page. The Configuration page
lists only one of the frame types that were successfully bound.
If you answer No to this option, you can select frame types manually. You must choose
at least one frame type to enable IPX/SPX protocols.
The frame selection screen allows you to make multiple selections. Depending on your
Port Setup selection, only Ethernet frame types or all frame types are displayed.
Press OK for each frame type used on your IPX/SPX network. An asterisk (*) appears
beside each selected frame type. Press the line selection button again to cancel a
selected frame type. Use the up and down arrow buttons to scroll to additional frame
types. The Fiery X3e binds to each frame type as you select it.
When you have selected all the frame types used, choose Exit IPX/SPX Setup.
Clear Frame Types
You can clear all frame types at once by choosing Exit IPX/SPX Setup, choosing
IPX/SPX Setup, and then choosing Clear Frame Types.