EFI KM-C1530 Configuration Manual page 66

4
4-12 Performing Setup from the Control Panel
Network Setup
Protocol Setup
TCP/IP Setup
TCP/IP Setup with Ethernet
Ethernet Setup
Enable TCP/IP for Ethernet
Yes/No [Yes]
Select Yes if you have a TCP/IP network connected to the Fiery X3e over Ethernet
cabling.
If you are using TCP/IP for printing from Windows computers, enabling
N :
OTE
TCP/IP here also enables you to use Fiery utilities from Windows computers using
TCP/IP protocols.
Enable Auto IP Configuration
Yes/No [Yes]
Select Yes to allow the Fiery X3e to obtain its Ethernet IP address by searching the
network. Depending on your network and the protocol you select in the following
option (DHCP or BOOTP), the IP address can change. Select No to assign the
Fiery X3e a static IP address. If you select No, you proceed to the IP Address option,
where you manually set the IP address.
Select protocol
DHCP/BOOTP [DHCP]
This option appears only if you answered Yes to Enable Auto IP Configuration. Select
the protocol over which the Fiery X3e should search for its IP address. Both DHCP
and BOOTP allow the Fiery X3e to obtain the Ethernet IP address and Subnet Mask
automatically.
Depending on your network, the Fiery X3e might be assigned a different address after
you restart the Fiery X3e. With the DHCP setting, the Fiery X3e can be assigned a
different address even if it is not restarted. Make sure the network is already configured
properly for the protocol you select.
Get Gateway Address Automatically
Yes/No [Yes]
Use this option to assign the gateway address automatically for printing with TCP/IP.