EFI KM-C1530 Configuration Manual page 81

4
4-27 Network Setup options
Network Setup
Service Setup
PServer Setup
Network Setup
Service Setup
Windows Setup
Polling Interval options
Polling Interval
Whether you use NDS or Bindery services, choose Polling Interval from the main
PServer Setup menu. If you do not reset the interval, the default value of 15 seconds
is used.
NetWare Server Poll Interval in Seconds
1–3600 [15]
Specify the interval, in seconds, at which the Fiery X3e communicates with the Novell
print server to see if there are print jobs waiting.
If you select a short interval, the amount of network traffic increases. This may
N :
OTE
slow down other network jobs.
Windows Setup options
Enable Windows Printing
Yes/No [Yes]
Enabling Windows Printing enables Server Message Block (SMB), the file and
printer sharing protocol built into Windows. Enabling SMB allows the Fiery X3e to
be listed on the network so that Windows clients can print to a particular print
connection (Hold, Print, or Direct) on the Fiery X3e without any other networking
software. For information on setting up a Windows computer for Windows
printing, see the User Software Installation
TCP/IP, so you must configure TCP/IP on the Fiery X3e and on all computers that
use Windows printing.
Guide. Windows printing runs via