Configuring A Netware 5.X Server For Printing - EFI KM-C1530 Configuration Manual

2
2-14 Setting up Network Servers
Configuring a NetWare 5.x server for printing
Before you begin
The following procedure assumes NDPS has been installed during NetWare 5.x
installation and that a Broker is running on the server. Unless you have manually
unloaded the Broker, it loads and runs when you install NDPS. Make sure you are
using the latest NetWare 5.x service pack and Novell gateway. Finally, create an NDPS
Manager. For more information, see your NetWare documentation.
In Fiery X3e Setup, make sure you have enabled TCP/IP
printing (page
verify that TCP/IP communication is successful.
Setting up the Fiery X3e printer driver
You first need to create a directory for Windows NT 4.0/2000/XP or a folder for
Windows 9x/Me in the NetWare server for NDPS to install the corresponding printer
driver files from the User Software CD.
T
O SET UP THE PRINTER DRIVER FOR
1. Log on to the Novell file server as a superuser or Administrator.
2. In the SYS:ndps\resdir\Prndrv\NT4/2000/XP directory, create a directory called Fiery.
3. From the User Software CD, copy the contents of the
ENGLISH\INSTALRS\PS_DRVR\WIN_NT/2000/XP folder to the Fiery directory.
T
O SET UP THE PRINTER DRIVER FOR
1. Log on to the Novell file server as a superuser or Administrator.
2. In the SYS:ndps\resdir\Prndrv\Win9x/Me directory, create a folder called Fiery.
3. From the User Software CD, copy the contents of the
ENGLISH\INSTALRS\PS_DRVR\WIN_9x/Me folder to the Fiery directory.
4-17) on the Fiery X3e. You can ping the Fiery X3e
W NT 4.0/2000/XP
INDOWS
W 9 /M
INDOWS X E
(page 4-11) and LPD
(page 2-18) to