EFI KM-C1530 Configuration Manual page 67

4
4-13 Network Setup options
IP Address
[127.0.0.1]
Enter the Fiery X3e IP address for Ethernet. This IP address, unlike an IP address set
automatically, remains the same if you restart the Fiery X3e. You must change the
default to a valid address for your network. For information about setting up printing
with TCP/IP, see
Subnet Mask
This option lets you modify the subnet mask for printing with TCP/IP over Ethernet.
To set the subnet mask, enter one of the following values:
• 255.0.0.0
•
255.255.0.0
• 255.255.255.0
Confirm the subnet mask setting with your network administrator before
N :
OTE
proceeding. In some cases, the required setting may be different from that listed.
Gateway Address
[127.0.0.1]
This option appears only if you answered No to Get Gateway Address Automatically.
Use this option to set the gateway address for printing with TCP/IP. If your network
uses a gateway, you must change the default to a correct gateway address for your
network.
Chapter 2.
if the IP address starts with a number less than 128
if the IP address starts with a number from 128 through 191
if the IP address starts with a number greater than 191