EFI KM-C1530 Configuration Manual page 53

3
3-9 About Setup
T F X3
O PREPARE FOR IERY
1. Print a copier Test Page to verify the copier is functioning normally.
2. Turn off the copier and connect the interface cable from the copier to the Fiery X3e.
3. To confirm this connection, turn on the copier and the Fiery X3e, and print a Test Page
from the Fiery X3e Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. Choose Print Pages, and then choose Test Page.
4. With both the Fiery X3e turned off, connect the network cable to the Fiery X3e, as
described in
The network should already be installed and operational.
5. Turn on the copier and then the Fiery X3e.
Proceed to Fiery X3e Setup, described in Chapter 4.
E CONFIGURATION
Chapter 1.