EFI KM-C1530 Configuration Manual page 42

2
2-18 Setting up Network Servers
T F X3
O SET UP IERY E PRINTING ON
1. Specify the appropriate settings in Fiery X3e Server Setup.
To access Fiery X3e Setup, see
2. Specify the appropriate settings in Fiery X3e Network Setup.
Enter a valid IP address, subnet mask, and gateway address for the Fiery X3e.
3. Specify the appropriate settings in Fiery X3e Printer Setup.
Publish the Print queue and/or Hold queue.
T TCP/IP
O SET UP FOR COMMUNICATION WITH THE
1. A superuser (with root login) must add the Fiery X3e to the network's IP host table or
other system database of network printers.
2. In the file or utility used by your network, specify the remote printer name, the print
server protocol, the queue, and the spool file for the Fiery X3e name you assigned.
3. Make the Fiery X3e available as a printer to other network users.
4. To verify the TCP/IP connection, ping the IP address or the host name. From any
computer on the network, at the command prompt, type:
ping <IP address>
Type the Fiery X3e IP address assigned in Fiery X3e Network Setup.
After the Fiery X3e is set up as a network printer, you can also ping the name you gave
to the Fiery X3e:
ping <hostname>
The server should respond with a message such as:
Reply from <IP address> ...
Some systems will respond with a continuous display of output from the IP address.
To stop the output, type
UNIX
SYSTEMS
page 4-3.
F X3
IERY E
You can use the
Control-C.
command at any time.
ping