Protocol Setup Options - EFI KM-C1530 Configuration Manual

4
4-11 Network Setup options
Network Setup
Protocol Setup

Protocol Setup options

To configure the Fiery X3e, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select Yes if you have an AppleTalk network connected to the Fiery X3e. This
setting enables the Fiery X3e to communicate over AppleTalk networks.
AppleTalk Zone
List of zones
The Fiery X3e searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the Fiery X3e to
appear. If your segment has only one zone, the Fiery X3e is assigned to that zone
automatically.
The message "No AppleTalk zone found" may mean your network has no zones, or the
network cable is not connected (see
TCP/IP Setup options
To configure the Fiery X3e for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings. Choose each network
type you use (Ethernet) and enter the appropriate settings.
When you set an IP address, subnet mask, or gateway address for the Fiery X3e during
Setup, you can allow the Fiery X3e to get these addresses automatically from a DHCP
or BOOTP server. First, turn on or restart the Fiery X3e and allow it to reach Idle.
Make sure the DHCP or BOOTP server is running, and then perform Fiery X3e
Setup.
Appendix A). Choose OK to dismiss the message.