Restart Backups; Return The Old Lcd Assembly To Spectra Logic - Spectra Logic Tape Series Instruction Manual

Replacing the T200, T380, or T680 LCD
5. Select Run Utility. The touch screen displays a series of calibration target
6. Touch each point as it displays with either your finger or a stylus to
7. When the calibration routine is complete, the Utilities screen

Restart Backups

Use your backup software to restart any backup processes running on
library.

Return the Old LCD Assembly to Spectra Logic

Refer to Return the Component on page
20
LCD Replacement Instructions
points.
recalibrate the touch points on the screen.
Note: Touch each point at a straight‐on angle as close to the center of
the target as possible.
redisplays.
55 for instructions.
90940065