Removing The Back Panel And Fan - Spectra Logic Spectra 2k AIT Install Manual

Removing the Back Panel and Fan

1. To remove the rear access panel, remove the two lowest screws on the back of the
library with the Phillips screwdriver (Figure 1), then lift the bottom panel and work
it down, so that the tongues at the top of the panel can clear their slots (Figure 2).
Use caution as the edges may be sharp
Figure 1 Remove the rear access panel screws.
Your library may look slightly different, depending
on the connectivity method the library uses.
2. Unplug the fan and serial port cables inside the Spectra 2K. Set the panel aside
(Figure 3).
Figure 3 Unplug the fan and serial port cables (Fibre Channel library
shown).
Spectra 2K Drive Installation Guide
Figure 2 Remove the rear access panel.
Serial port cable
5
Fan
cable