Configuring Mpls Protocol (Nsm Procedure); Enabling Mpls On The Router (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring MPLS Protocol (NSM Procedure)

Enabling MPLS on the Router (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring RSVP (NSM Procedure) on page 351
Configuring Layer 2 Circuit (NSM Procedure) on page 259
You can enable MPLS on the router using the MPLS option. See the following topics:
Enabling MPLS on the Router (NSM Procedure) on page 281
Configuring Administrative Group (NSM Procedure) on page 284
Configuring Administrative Groups (NSM Procedure) on page 284
Configuring Bandwidth for the Reroute Path (NSM Procedure) on page 285
Configuring DiffServ-Aware Traffic Engineering (NSM Procedure) on page 286
Configuring MPLS on Interfaces (NSM Procedure) on page 287
Configure a Label Switched Path (LSP) to Use in Dynamic MPLS on page 289
Configuring System Log Messages and SNMP Traps for LSPs (NSM
Procedure) on page 314
Configuring BFD for MPLS IPv4 LSPs (NSM Procedure) on page 315
Configuring Named Paths (NSM Procedure) on page 317
Configuring MTU Signaling in RSVPs (NSM Procedure) on page 318
Configuring static LSPs on the Ingress Router (NSM Procedure) on page 319
Configuring MPLS Statistics (NSM Procedure) on page 320
Tracing MPLS Packets and Operations (NSM Procedure) on page 321
You can enable MPLS on the router using the MPLS option.
To enable MPLS on the router in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Mpls.
4.
Add or modify settings as specified in Table 142 on page 282.
5.
Click one:
6.
OK-Saves the changes.
Cancel-Cancels the modifications.
Chapter 20: Configuring Protocols
281