Create Remote Replication - Dell PowerVault MD3620f Command Line Interface Manual

Create Remote Replication

NOTE:
This command valid only with Fibre Channel storage arrays.
This command creates both the primary virtual disk and the secondary virtual
disk for a remote replication pair. This command also sets the write mode
(Synchronous or Asynchronous) and the synchronization priority.
Syntax
create remoteReplication primary=
"primaryVirtualDiskName"
secondary="secondaryVirtualDiskName"
(remoteStorageArrayName="storageArrayName" |
remoteStorageArrayWwn="wwID")
[remotePassword="password"
syncPriority=(highest | high | medium | low |
lowest)
autoResync=(enabled | disabled)
writeOrder=(preserved | notPreserved)
writeMode=(synchronous | asynchronous)]
Parameters
Parameter
primary
secondary
remoteStorageArrayNam
e
remoteStorageArrayWwn The World Wide Identifier (WWID) of the remote
Description
The name of an existing virtual disk on the local
storage array that you want to use for the primary
virtual disk. Enclose the primary virtual disk name in
double quotation marks (" ").
The name of an existing virtual disk on the remote
storage array that you want to use for the secondary
virtual disk. Enclose the secondary virtual disk name
in double quotation marks (" ").
The name of the remote storage array. Enclose the
remote storage array name in double quotation
marks (" ").
storage array. Enclose the WWID in double
quotation marks (" ").
Script Commands
173