Dell PowerVault MD3620f Command Line Interface Manual page 21

Table 1-2. Command Line Parameters
Parameter
-c
-d
-e
-F (uppercase)
-f (lowercase)
(continued)
Definition
Use to indicate that you are entering one or more script
commands to run on the specified storage array. Terminate
each command by using a semicolon (;).
You cannot place more than one -c parameter on the same
command line. You can include more than one script
command after the -c parameter.
Use to display the contents of the script configuration file.
Use to disable syntax checking when executing the current
CLI command.
Use to specify the e-mail address from which all alerts will
be sent.
Use to specify a file name containing script commands
intended to run on the specified storage array.
This parameter is similar to the -c parameter in that both
are intended for running script commands. The -c
parameter allows you to execute individual script
commands. The -f parameter allows you to execute script
commands contained in a file.
NOTE:
By default, any errors encountered when running the
script commands in a file are ignored, and the file continues
to run. To override this behavior, use the set session
errorAction=stop command in the script file.
About the Command Line Interface
21