Dell PowerVault MD3620f Command Line Interface Manual page 264

Parameters
Parameter
allVirtualDisks
virtualDisk or
virtualDisks (name)
virtualDisk
cacheFlushModifier
cacheWithoutBatteryEnabled The setting to turn on or turn off caching
mediaScanEnabled
mirrorCacheEnabled
264
Script Commands
Description
Specifies the properties for all virtual disks in
the storage array.
Specifies the name of the virtual disk for
which to define properties. You can enter
more than one virtual disk name if you use the
virtualDisks parameter. You must put
quotation marks (" ") and brackets ([ ])
around the virtual disk name. The virtual disk
name and quotation marks must be inside the
brackets.
Specifies the WWID of the virtual disk for
which you are setting properties. You can use
the WWID instead of the virtual disk name to
identify the virtual disk. You must put angle
brackets (< >) around the WWID.
The maximum amount of time that data for
the virtual disk stays in cache before the data
is flushed to physical storage. Valid values are
listed in the Notes section.
without batteries. To turn on caching without
batteries, set this parameter to TRUE. To turn
off caching without batteries, set this
parameter to FALSE.
The setting to turn on or turn off media scan
for the virtual disk. To turn on media scan, set
this parameter to TRUE. To turn off media
scan, set this parameter to FALSE. (If media
scan is disabled at the storage array level, this
parameter has no effect.)
The setting to turn on or turn off the mirror
cache. To turn on the mirror cache, set this
parameter to TRUE. To turn off the mirror
cache, set this parameter to FALSE.