Dell PowerVault MD3620f Command Line Interface Manual page 145

single parameter or all of the parameters to meet your configuration
requirements. After entering the autoConfigure storageArray command, the
RAID controller modules set up the storage array using either the default
parameters or those you selected.
Syntax
autoConfigure storageArray
physicalDiskType=(SAS)
raidLevel=(0 | 1 | 5 | 6)
diskGroupWidth=numberOfPhysicalDisks
diskGroupCount=numberOfDiskGroups
virtualDisksPerGroupCount=
numberOfVirtualDisksPerGroup
hotSpareCount=numberOfHotSpares
segmentSize=segmentSizeValue
cacheReadPrefetch=(TRUE | FALSE)
securityType=(none | capable | enabled)]
Parameters
Parameter
physicalDiskType
raidLevel
diskGroupWidth
diskGroupCount
virtualDisksPerGrou
pCount
Description
Type of physical disks to use for the storage array.
Valid physical disk type is Serial Attached SCSI
(SAS). This parameter is not required if only one
type of physical disk is in the storage array.
RAID level of the disk group that contains the
physical disks in the storage array. Valid RAID
levels are 0, 1, 5 or 6.
Number of physical disks in a disk group in the
storage array. For information about the number
of physical disks that you can use in a disk group,
see "Enclosure Loss Protection" on page 54.
Number of disk groups in the storage array. Use
integer values.
Number of equal-capacity virtual disks per disk
group. Use integer values.
Script Commands
145