Show Raid Controller Module Nvsram - Dell PowerVault MD3620f Command Line Interface Manual

Show RAID Controller Module NVSRAM

This command returns a list of the NVSRAM byte values for the specified
host type. If you do not enter the optional parameters, this command returns
a list of all NVSRAM byte values.
Syntax
show (allControllers | controller [(0 | 1)])
NVSRAM [hostType=(hostTypeIndexLabel | host=
"hostName")]
Parameters
Parameter
allControllers Returns information about both RAID controller modules in the
controller
hostType
host
NOTE:
Use the show controller NVSRAM command to display parts or all of the
NVSRAM before using the set controller command to change NVSRAM values.
278
Script Commands
Description
storage array.
Returns information about a specific RAID controller module in
the storage array. Valid RAID controller module identifiers are 0
or 1, where, 0 is the RAID controller module on the left and 1 is
the RAID controller module on the right when viewed from the
rear of the enclosure. You must put brackets ([ ]) around the
RAID controller module identifier.
Specifies the index label or number of the host type. Use the
show storageArray hostTypeTable command to generate a list of
available host type identifiers.
Specifies the name of the host connected to the RAID controller
modules. You must put quotation marks (" ") around the
host name.