Set Host - Dell PowerVault MD3620f Command Line Interface Manual

Set Host

This command assigns a host to a host group or moves a host to a different
host group. You can also create a new host group and assign the host to the
new host group with this command. The actions performed by this command
depend on whether the host has individual mappings or does not have
individual mappings.
Syntax
set host [hostName]
hostGroup=("hostGroupName" | none | defaultGroup)
userLabel="newHostName"
hostType=(hostTypeIndexLabel |
hostTypeIndexNumber)
Parameters
Parameter
host
hostGroup
userLabel
hostType
232
Script Commands
Description
The name of the host that you want to assign to a host group.
Enclose the host name in square brackets ([ ]). If the host name has
special characters, you must also enclose the host name in double
quotation marks (" ").
The host group to which you want to assign the host. (The following
table defines how the command runs if the host does or does not
have individual virtual disk-to-LUN mappings.) Enclose the host
group name in double quotation marks (" "). The defaultGroup is
the host group that contains the host to which the virtual disk is
mapped.
The new host name. Enclose the host name in double quotation
marks (" ").
The index label or number of the host type for the HBA host port.
Use the show storageArray hostTypeTable command to generate a list
of available host type identifiers. If the host type has special
characters, enclose it in double quotation marks (" ").