Dell PowerVault MD3620f Command Line Interface Manual page 143

freeCapacityArea
repositoryPhysicalDiskCount
enclosureLossProtect
Notes
If the physical disks selected for the repositoryPhysicalDisks
parameter are not compatible with other parameters (such as the
repositoryRAIDLevel parameter), the script command returns an error,
and Remote Replication is not activated. The error returns the amount of
space that is needed for the replication repository virtual disk. The command
can then be re-entered with the appropriate amount of space specified.
If a value is entered for the repository storage space that is too small for the
replication repository virtual disks, the RAID controller module firmware
returns an error message that provides the amount of space that is needed for
the replication repository virtual disks. The command does not try to activate
Remote Replication. The command can be re-entered using the value from
the error message for the repository storage space value.
The index number of the free space in an
existing disk group that you want to use to
create the replication repository virtual
disk. Free capacity is defined as the free
capacity between existing virtual disks in a
disk group. For example, a disk group
might have the following areas: virtual disk
1, free capacity, virtual disk 2, free capacity,
virtual disk 3, free capacity. To use the free
capacity following virtual disk 2, you
would specify:
freeCapacityArea=2
Run the show diskGroup
to determine if a free capacity area exists.
The number of unassigned physical disks
that you want to use for the replication
repository virtual disk.
The setting to enforce enclosure loss
protection when you create the replication
repository virtual disk. To enforce
enclosure loss protection, set this
parameter to TRUE. The default value is
FALSE.
Script Commands
command
143