Set Storage Array Unnamed Discovery Session
This command enables the storage array to participate in unnamed discovery
sessions.
Syntax
set storageArray unnamedDiscoverySession=(TRUE |
FALSE)
Parameter
Parameter
unnamedDiscoverySession This parameter turns on or turns off unnamed
NOTE:
Discovery is the process where initiators determine the targets that are
available. Discovery occurs at power-on/initialization and also if the bus topology
changes, for example, if an extra device is added.
NOTE:
An unnamed discovery session is a discovery session that is established
without specifying a target ID in the login request. For unnamed discovery sessions,
neither the target ID nor the target portal group ID are available to the targets.
Set Virtual Disk
This command defines the properties for a virtual disk. You can use most of
the parameters to define properties for one or more virtual disks, however,
some of the parameters define properties for only one virtual disk at a time.
The syntax definitions are separated to show which parameters apply to
several virtual disks and which apply to only one virtual disk. The syntax for
virtual disk mapping is listed separately.
Syntax Applicable to One or More Virtual Disks
set (allVirtualDisks | virtualDisk
["virtualDiskName"] |
virtualDisks ["virtualDiskName1" ...
"virtualDiskNameN"] |
262
Script Commands
Description
discovery sessions. Set the parameter to TRUE to
turn on unnamed discovery sessions. Set the
parameter to FALSE to turn off unnamed
discovery sessions.